KT-D12L Pedal Sensor for Left Side

It’s probably very good. But I didn’t get the chance to fit it, as the rear 350 watt hub wheel didn’t fit my bicycle frame. So I returned it to YosePower.

the KT-D12L Pedal Sensor arrived in a clear plastic bag within an envelope, no instructions how to fit and as I learnt later needed a 3mm approx air gap to the receiver. A download came after complaining by which time I had found a YouTube showing everthing.

I couldn't use the supplied PAS Sensor as I had a splined bottom bracket on my bike but this one fitted perfectly. Thank you Yose.

This fitted better than the one supplied with the original kit. The pedal shaft widened out before the bottom bracket and the sensor would not move past this point. The alternative one supplied worked well after a slight problem fixing it in position - used superglue and cable tie for perfect location.

Purchased as a spare just in case. The whole Yose system is first class.

KT-D12L Pedal Sensor for Left Side

A great help for my conversion as I didn't want to remove the crank arm, works very well its easy to set up and delivery's fast as well

I had a "one piece" LH side sensor with my kit which wouldn't stay in the recess of the bottom bracket on my bike and was moving outboard onto the square taper of the spinde. This led to a delay in the PAS engaging and eventually not working at all. I tried putting rubber "O" rings on the spindle behind the crank arm but there were still problems This was a problem with the bike rather than the sensor as I have one on another bike and it works fine.
The KT-D12L solved the problem. It may not be as neat-looking but it was easy to fit and has stayed where I put it!

Easy to fit works perfect